20 Servo-Shift Pressure Adjustment. To adjust the servo-shift hydraulic pressure, remove the headstock cover. Remove the small pipe plug in the front hydraulic cylinder, opposite the pressure line. Insert a pressure gauge as shown on page The gauge should be graduated to about P.S.I. Start the hydraulic pump. Loosen the lock nut on the4/5(4). LATHES MAJOR FEATURES Designed and built with the same care as LeBlond Heavy Duty Lathes, Regals give long life, precision production, minimum maintenance and dependability expected only from much higher priced machines. • All standard Regal Engine Lathes have Servo-Shift as standard, allowing further time savings with pre-selection. · Number of Pages: 71 This is a reproduction, not a photocopy, of an original LeBlond Regal 13″, 15″, 17″, 19″ Lathe Instruction and Parts Manual No. Contents: SPECIFICATIONS 3 INSTALLATION Dimension Drawings 5 Foundation 8 Cleaning 8 Moving and Lifting 8 Electrical Connections 9 Leveling 9 LUBRICATION 10 OPERATING INSTRUCTIONS Headstock Controls [ ]Estimated Reading Time: 50 secs.
Number of Pages: 71 This is a reproduction, not a photocopy, of an original LeBlond Regal 13″, 15″, 17″, 19″ Lathe Instruction and Parts Manual No. Contents: SPECIFICATIONS 3 INSTALLATION Dimension Drawings 5 Foundation 8 Cleaning 8 Moving and Lifting 8 Electrical Connections 9 Leveling 9 LUBRICATION 10 OPERATING INSTRUCTIONS Headstock Controls [ ]. converting LeBlond servo shift to manual ship. I have a Regal servo out here at the farm on a phase converter and the shifter doesn't work. It didn't work very well in town on real 3 phase for that matter. I know LeBlond sells a kit to change them over but it is a little pricey. Iv purchased several pieces of equipment recently, but the most recent being a model year Leblond Regal Servo Shift 15x Leblond, being super helpful, sent over the original purchasing/build documents. This is a one owner machine, purchased by a trade school, then purchased by myself. Further inspection has gone rather well, so far no.
Equipped With: Hendenhain 2-Axis DRO, 8" 3-Jaw Chuck, Chuck Guard, 4-Way Tool Post, Steady Rests, Chip Pan, Rear chip Guard, Work Light, Machine Manual. Swing over bed: 15", Swing over cross slide: 9", L0 NOSE 8in. 4 JAW CHUCK CHUCK CHIP GUARD SPECIFICATIONS SUBJECT TO VERIFICATION CASH. Unfortunately, the Servo-shift headstock proved to be a mistake; to be kind it was a good idea that failed in its execution (and one that other American.
0コメント